|
|
Clean and dry surfaces thoroughly. If necessary, remove paint, old glue, etc. Sand or plane wood
surfaces so that the surfaces to be bonded are flat. Remove oil and dust from metal surfaces. For
best results the metal should be cleaned with a solvent that contains acetone.
Squeeze a small amount of Instant Krazy Glue® onto one of the surfaces to be glued. Use one
drop per square inch. If you use too much glue, the time it takes to bond will be much longer,
or it may not bond at all.
Now, join the parts and press for 30 seconds. Make sure that the parts are stable, and allow to set
for a few minutes. Allow the glue to cure overnight for maximum strength.
Be sure to close the container tightly and store it in a cool, dark place so that your Instant
Krazy Glue® stays fresh.
|
|
 |
|
